Paquete de 6 correderas de campana negras, pies de silla de oficina de alto perfil de 11 mm | Cuerpo de nylon, vástago de acero, altura de 82 mm, base de 50 mm, anillo de agarre de 22 mm, instalación a presión, se adapta a los taburetes

Descripción

JAKOUE Black High Profile Bell Glides for office chairs replace rolling casters with stationary feet. These office chair glides fit a five leg base with one spare, dropping into the socket your chair wheels came out of. No drilling or adapters needed.11mm x 22mm Grip Ring FitThe shaft measures 11mm across with a sprung retaining ring and 22mm exposed length, the 7/16 by 7/8 inch size on most office chair wheels, desk chair wheels and computer chair wheels sold in the US. Not for IKEA chairs, which need a 10mm stem.82mm High Profile BodyThe bell shaped body stands 82mm tall with 22mm above the socket. Seat height stays near the original caster setting, and the 50mm base contacts more floor than a thin wheel edge.Black Nylon and SteelA black nylon housing carries a steel grip ring stem. The wide bottom meets hardwood, tile, laminate, vinyl plank and low pile carpet, blending with most black chair bases.Skip the New BaseInstead of replacing the entire chair base, change only the contact points. This set converts rolling casters into stationary feet, providing a stable alternative for task seating, workstations, and home office setups.Install in MinutesTip the chair, pull each caster, align the stem and press until the ring clicks. Repeat five times. Nothing threads, nothing needs a wrench.Where They GoHome offices, workbenches, sewing tables, salon stations, classrooms, gaming corners. Anywhere a chair rolls away on a sloped floor.What's Inside6 x black high profile bell glides, 50mm base, 82mm height, 11mm x 22mm stem. Wipe with a damp cloth and let air dry when grit collects.

Características

• Set of 6 black bell glides replaces casters on a standard five leg office chair base and leaves one spare. Each unit carries an 11mm grip ring stem and 22mm exposed shaft, the 7/16 by 7/8 inch size used as casters for office chair, chair casters, office chair casters and computer chair wheels sold in the US. They push into the socket your old caster came from, creating an office chair no wheels setup. Compatible with 11mm stems (not compatible with 10mm stems.
• High profile chair glides keep your seat at the same height it had with casters. The black nylon body stands 82mm tall in total, with 22mm stem rising above the socket line, while the bell shaped base spans 50mm across the floor. That added height matches most original casters and avoids the lowered feel that comes with shorter fixed feet, so your desk and armrests stay at the familiar level.
• Built with a black nylon bell housing over a steel stem. The wide bottom sits flat on hardwood, tile, laminate, vinyl plank and low pile carpet, working the way chair slides do when you want smooth movement without rolling. The dark black finish blends with most black chair bases and the steel stem stays hidden inside the socket after installation.
• Installation needs no tools at all. Grip the old caster, pull it straight out of the socket, line up the 11mm stem and press down until the retaining ring clicks home. Six pieces go in under five minutes, so a full office chair wheel replacement or chair wheel replacement job is done before your coffee cools. The swap works as fixed caster wheels and replacement wheels for office chair bases, turning a rolling chair into a stationary one.
• Use them anywhere a seat should hold position: home office setups, workbenches, craft and sewing tables, salon stations, art studios and gaming corners. They also answer sloped or uneven flooring where wheels creep on their own, acting as a gaming chair wheel stopper or a replacement kit for task seating. The six piece pack fits one chair in full and keeps a spare on hand for the next repair.

Especificaciones