G-Penny 1.5KW ER11 Air Cooled CNC Spindle Kit 65mm 220V 0-24000RPM 0.01mm Runout, Includes H100 Inverter & 65mm Fixing Bracket(220V)

Descripción

Product description Basic parameter Size: 65*204mm Speed Ways: Through 3-phase output inverter and adjust the inverter frequency to change the spindle speed. Cooling: Air cooling Power: 1.5kw (1HP=0.735kw) Collet: ER11 Voltage: 220v Current: 6A Frequency: 400HZ Speed: 0-24000rpm Runout Off: 0.01mm Full sealed angular contact bearings Grease Lubrication We are the spindle manufacturer,we use better material to produce the spindle. 1.We use steel bearings seat,spindle will not morph during the using life.Increase the spindle using life. 2.We use 4 pcs 7 series fully sealed angular contact ball bearings, it quality much better, usually use it 1-2 years without any problems. 3. Full power spindle, stronger shaft and coil,more power in engraving and cutting working. 4. Precision 0.01mm.Coaxial degree less than 0.0025mm,suitable for high accuracy work. 5. Carefull assembly make the spindle more precisional. 3-4 hours testing after assemble, 99.9% pass rate. No worry after ordering. 6. We work with biggest CNC router manufacturer in USA, EU,RU. Strong work partners. Basic parameter Power: 1.5KW Input voltage: 220v Input phase: 1 or 3Phase Input Frequency: 50-60Hz Output Voltage: 220v Output Phase: 3 phase Output Current: 7A Output Frequency: 0-1000Hz Control Method: V/F Control Basic parameter Diameter: 65mm Material: Cast Aluminium Features: Compared with the aluminium profile fixture,the accuracy is much higher , and it is hard to deform. Inner wall is very smooth, outer walls is sandblasted, relatively fine uniform, but not very smooth. Cast aluminium fixture is much heavier than aluminium profile fixture. Product Description Cast aluminium fixture is high quality aluminium which is casting with a special manufacturing process ,compared with ordinary aluminium ,This product has toughness, strong shock resistance, high hardness and strong antioxidant activity. Usage Cast aluminium fixture is mainly used for fixation of ancillary products, thereby ensuring the verticality of balancing and ancillary products, ancillary products to improve running accuracy, reduce noise, reduce the accumulated error. If the spindle will not be used for a long time, please keep the spindle oil sealed to prevent rust from being unused for a long time. Before shipping , we did the oil seal to avoid the rust during the long shipment. When you get the spindle, please clearing the oil seal before using. Thank you. Water cooled spindle MUST be used with water pump. Otherwise the spindle will soon broken. AC spindle motor MUST use with inverter. The power of inverter need equal or bigger than the spindle power. Before using,please set up the inverter parameters suitable for spindle. Otherwise the spindle and inverter will broken at once. When you use the spindle,the noise is not same as always,please STOP the spindle at once. You may need to replace the spindle bearings.

Características

• AC 220V Spindle motor ( Must need connect to inverter/VFD)
• 4pcs 7series angular contact bearing, exterd the spindle using life.
• Spindle connect to GND, Pin-4 connect to inverter GND.
• Spindle 1-2-3 connect to inverter U. V. W.

Especificaciones