3 tiras de cinta de repuesto para selladores al vacío, tiras de sellado térmico, se adapta a Food Saver

Descripción

Product description Ready to order a new food saver machine? DON’T WASTE YOUR MONEY!LOOK HERE! If the only problem you are having with your vacuum sealer is the adhesive heat strip is not sealing completely, and will not maintain the vacuum created, then you should give this solution a try before spending your money on a whole new machine. For very little money, this tape will fixed your problem entirely. The installation takes only seconds and is a no brainer. The result is our ten year old unit works like new again. Package including: 3 heat tape strips with size 18inch long and 1/2inch width Easy to tear longer release paper design High temperature resistant gum It can work normally at - 100-500 ° F Easy to use Cut the new food saver sealing strip to size with sharp scissors WIDELY USED IN ALL VACUUM SEALER MACHINES: Birllaid food saver tape work in all vacuum sealers. HOW TO INSTALL: 1)Pulling the old tape off and cleaning the heat strip well 2)Cut the new tape to the correct size with sharp scissors 3)Remove the yellow backing from the tape and place over the heating element (under the element if using for an impulse sealer). Smooth out the tape with your finger as you go, to ensure a good bond Just be sure of what is wrong with your unit before buying so you can avoid disappointment See More

Características

• Work perfectly for your vacuum sealer:If your Food Saver have difficult time in sealing bags, the vacuum sealer tape is probably just worn out and needs to be replaced. Replacing your heat strip is recommended if it appears worn or you've run in to any problems with sealing
• Easy to use,After pulling the old tape for vacuum off and cleaning the heat strip well,then cut the new food saver sealing strip to size with sharp scissors, peeling the backing off the tape and stuck it on.very easy to install and extended the life of your food saver .Application was easy and it works great
• PACKAGE:3 food saver Strips are each 18 inches long x 0.5 inches wide. These are purposely slightly longer and wider than necessary, simply trim length to fit your sealer model
• WIDELY USED IN ALL VACUUM SEALER MACHINES: Birllaid food saver tape work in all vacuum sealers
• The extra width gives you a bit more room to ensure proper coverage

Especificaciones