BEN YEDD 2025 Nueva máquina de tejer i Cord Molino de tejer cuerda Máquina de trenzado de extremo medio Estilo de techo Doble guía Ranura de la boca Artefacto de tejido mejorado Cuerda de hilo Herramienta de bricolaje (rosa y blanco)

Descripción

Product description Read the following instructions thoroughly before using the product; otherwise, malfunctions or errors are highly likely to occur. List of yarns suitable for knitting Our machine is not compatible with all types of yarn. We conducted tests using 4-ply pure wool yarn, which has a diameter of approximately 2 mm when relaxed. The counterweight weight is calibrated to ensure smooth knitting with this 4-ply pure wool yarn. If you use other yarn varieties, you will need to adjust the counterweight weight up or down according to actual usage conditions. Please start the initial operation as shown in the picture. Key important points during the operation to make a successful yarn rope: 1, (use small tool open all the four latches of the four needles)in the beginning, when you thread the yarn into the side guide(Lower guide) and Upper guide, especially from the second lap of the four needles in the top, your hand should not press or touch the yarn at side body of machine when yarn comes in which will affect the operation, you must let yarn free, your hand can only hold the body of machine No Yarn (very important!) 2, (first lap you should let yarn hook in the first needle, skip the second needle, hook in the third needle and skip the fourth needle)when you start to use it especially from the second lap of the four needles in the top, you have to put on the load-bearing clip and keep the clip in a suspended state all the time, otherwise it will not work well 3, after the yarn rope come out a few like 30 cm long, then you must take the load-bearing clip up again of the out coming rope to the outer bottom hole to keep enough correct load-bearing to make it work to avoid the the insufficient load-bearing capacity leads to mistake(when the rope come out a lot you can use something like rubber bands to tidy the ropes as a ball to make it easy to control) (very important!) 4, since you may use different kinds of yarns or threads to try, like more thickness or more thinness yarn or some kind of special threads, we suggest you add some more load-bearing beside the clamp if you use more thick yarn to help it goes into the middle hole of machine and the rope can comes down well, if you use more thin yarn, then you can try more light load-bearing to instead of the current clamp if you find the operation is not very smoothly. You can feel free to adjust the load-bearing to find a best alternative to fit your own yarn to make the best comfortable operation. (if you understand this point you can be an expert) 5, for how to choose the two top Upper guides, you can choose either one based on your best comfortable operation experience, either one is OK. Before you use it, please must read the above five key important notice first!!! After completing the preliminary steps, release the yarn outside the thread inlet.Ensure the load clip stays under load during knitting at all times. Comparison of new wire ports Two-color combination There are two wire ports Display of logo position Special wear-resistant material layer is applied on frequently rubbed areas. See More

Características

• Rope knitting tool
• Rope making
• Double wire port rope braider
• i cord
• Double Guide Mouth

Especificaciones