Generac 7102 Kit de calentador de aceite para generadores de reserva enfriados por aire de 9 kW a 22 kW, naranja | Para generadores de reserva enfriados por aire de 9 kW a 22 kW kilovatios, naranja

Descripción

The Generac 7102 Cold Weather Oil Warmer Kit keeps crankcase oil at safe operating temperatures during freezing weather so your air-cooled standby generator starts reliably when a winter outage hits — not sluggishly, not with excessive wear, and not with a nuisance ""False Start"" alert caused by cold, thick oil. Which generators does it fit? This kit is designed for Generac air-cooled standby generators in the 9–26 kW range manufactured in 2008 or later. It also fits Honeywell and Centurion standby generators built by Generac where engine specifications align. This kit is not compatible with portable generators. How does the thermostat work? The built-in thermostat automatically activates the heater when ambient temperature drops to 40°F and shuts it off when temperatures rise back to 55°F. No seasonal plugging and unplugging is needed — it is safe to leave connected all year. Does it run off the generator battery? No — the 7102 draws 50W / 0.21A from the utility line through the transfer switch's N1/N2 control circuit. It does not operate while the generator is running and will not drain the starter battery. Does synthetic oil replace this kit? No. Generac requires 5W-30 full synthetic oil when the 7102 is installed, but synthetic oil alone does not keep crankcase oil warm enough in sub-freezing conditions. Both are necessary for reliable cold-weather starts. Do I need the 7101 battery warmer too? The 7102 heats only the oil filter. The 7101 battery warmer pad sits under the starter battery and is sold separately. For climates that regularly drop below 32°F, Generac recommends using both kits together. The 7103 breather heater is available for extreme cold on 2013+ models. Can I install it myself? Yes — the silicone loop slips over the oil filter without draining oil, and no specialty tools are required. The included instruction sheet guides the full installation. A licensed electrician is recommended for any N1/N2 control circuit wiring.

Características

• FITS 9–26 KW GENERAC AIR-COOLED STANDBY GENERATORS MADE IN 2008 OR LATER: Compatible with Honeywell and Centurion models manufactured by Generac where engine specs match; not designed for portable generators
• THERMOSTAT ACTIVATES AT 40°F AND SHUTS OFF AT 55°F AUTOMATICALLY: Heater engages only when crankcase oil temperature drops into the cold-start danger zone, preventing thick oil from causing hard starts or engine wear
• SLIPS DIRECTLY OVER THE OIL FILTER — NO OIL DRAIN REQUIRED TO INSTALL: The orange silicone heating loop slides over the existing oil filter in minutes without removing or draining oil, reducing installation time significantly
• RUNS ON 240V UTILITY POWER AT JUST 50W AND 0.21A FROM THE N1/N2 CIRCUIT: Draws power directly from the utility line through the transfer switch control circuit — it does not draw from or drain the generator's starter battery
• BUILT-IN THERMOSTAT RUNS AUTOMATICALLY YEAR-ROUND WITHOUT MANUAL UNPLUGGING: Heater self-regulates based on ambient temperature and only operates on utility power — it is inactive while the generator is running during an outage
• THIS KIT HEATS THE OIL FILTER ONLY — BATTERY WARMER (MODEL 7101) IS SOLD SEPARATELY: The 7102 protects crankcase oil viscosity; the 7101 protects the starter battery; both are recommended for climates that regularly drop below freezing
• 5W-30 FULL SYNTHETIC OIL IS REQUIRED WHEN THIS KIT IS INSTALLED — NOT A SUBSTITUTE FOR IT: Synthetic oil alone does not provide sufficient cold-start protection below freezing; the 7102 heater and 5W-30 synthetic oil work together as a system
• WHAT'S INCLUDED: Orange silicone oil filter heating loop, wire harness, mounting zip ties, and installation instruction sheet; engine oil and battery warmer pad (model 7101) are sold separately

Especificaciones